 |
| #1 Route wires. I like using Taylor Cable looms. |
 |
| Tools needed spark plug wire crimpers, needle nose pliers, side cutters and WD40 |
 |
| clip a connector on cap cut wire 3/4" longer than needed |
 |
| insert wire into crimper/stripper leaving 3/4" sticking out |
 |
| wire should look like this after stripping |
 |
| fold inner wire back |
 |
| place connector over wire, making sure inner wire is at the top of connector. slightly squeeze connetor on wire to keep it in place |
 |
| insert into crimper, making sure connector in properly located |
 |
| this is what it will look like crimped |
 |
| install wire on cap and repeat 7 more times |
 |
| spray WD40 into boot |
 |
| insert needle nose pliers into boot |
 |
| work the pliers in & out while twisting the boot a few times. you will be able to feel when ready. |
 |
| push connector into boot and repeat 7 more times |
 |
| Your finished. Now grab a cold drink, sit back and enjoy not having ugly plug wires. |
